Oce 9400-II User Manual page 17

During the copying process:
If you press this button while an original is being fed, the copying process
will stop immediately. If you want to abort a multicopy job after the scanning
of the original is finished, you must abort the copying process by pressing the
'cancel/continue' button on the printer. You have to open the top cover of the
scanner to remove the original ('Clearing original jam' on page 126).
With this button you choose the input of the copy material.
Media button
Possible input selections are roll 1, roll 2 or manual feed.
You modify the exposure level with the 'lighter' and 'darker'
Exposure scale
buttons. The exposure level can be changed at all times.
Auto exposure button
Compensation can be switched on or off.
This button toggles between synchro cut mode and standard cut
Cut button
mode.
In synchro cut mode, the copy is cut at the length of the original.
In standard cut mode, the copy is cut at a standard length.
This button toggles between leading and trailing edge. With this
Edge button
button you add or remove a strip at the leading or trailing edge.
You can vary the zoom factor between 25% and 400%. Either in
Zoom button
fixed steps or percentages.
When using zoom-, edge- or the standard cut-mode you can
Up/Down buttons
modify the values of these modes by pressing the up or down button.
This indication above the start button is on if the scanner is
Start indication
ready to make a scan and is off when the scanner is scanning an original. Also
this is the only indication which is on when the scanner is in standby mode.
This indication is blinking when the user has pressed the start
Please wait
button but the system is not ready to scan. E.g. because the system is busy with
a multicopy job or because the system is processing a printjob.
This indication is on if there is an error on the printer. Check the
Printer error
operating panel of the printer for the error message.
Getting started
With this button the Automatic Background
17