Switching On/Off The Copier - Oce 9400-II User Manual

Switching on/off the copier

Switching on the copier consists of:
switching on the scanner
switching on the printer (see page 19).
After switching on the system is ready for operation. In this state, the machine
is in stand-by mode. There is no need to switch it off after each copy job. You
can leave the copier switched on for the rest of the day. At all times, the Océ
9400-II is ready for operation.
If the copier has been inactive for more than 1 minute, the operating panel
returns automatically to the stand-by mode. The operating panel of the scanner
is activated in the following situations:
you feed an original
a button on the operating panel is pressed
Switching on the scanner
Set the on/off switch at the rear of the scanner, to position '1' (see figure 3). If
1
the mains is connected correctly, the green switch will light up.
[3] On/off switch of the scanner
The system is immediately ready for use. The scanner can be switched on
Note:
and off independently from the printer and without any particular order.
Switching off the scanner
Set the on/off switch at the rear of the scanner, to position '0' (see figure 3).
1
18 Océ 9400-II User Manual