Oce 9400-II User Manual page 38

Setting the bitmap buffer
Press 'Program' to enter the main menu.
1
Select the 'C
2
Press 'next/select' to enter the 'C
3
Select the '
4
Press 'next/select' to enter the '
5
Select the '
6
Press 'next/select' to enter the '
7
Select the required bitmap partition using the
8
Press 'next/select' to confirm the required partition.
9
Press 'Program' to leave the main menu.
10
Activating the new bitmap buffer size
Switch the printer off and then on again.
1
If you do not restart the printer the new memory allocation is not taken
Note:
into account. Any print data in the printer's memory will be lost when you
switch off the printer.
RAM
64
128
256
The presented memory percentages are only an indication and may vary
Note:
a little from one firmware release to another one.
If you experience difficulties to print your files with these settings, then you
can try to change the value knowing that:
Increasing the bitmap buffer size, decreases the processing area size.
The size of the processing area determines the ability to process complex
files (e.g. larger number of vectors).
A high percentage of bitmap partition allocation, allows printing of long
plots without windowing.
A low percentage of bitmap partition allocation, means the ability of
processing very complex files (vector and raster).
38 Océ 9400-II User Manual
' item using the
ONFIGURATION
' item using the
BUFFERS
' item using the
BITMAP BUFFER
Min
31 % (E+ paper)
16 % (E+ paper)
9 % (E+ paper)
or
' menu.
ONFIGURATION
or button.
' menu.
BUFFER
or
' menu
BITMAP BUFFER
or
Max
71 % (2.92 meters on E+ paper)
78 % (6.41 meters on E+ paper)
84 % (13.82 meters on E+ paper)
button.
button.
button