Introduction - Oce 9400-II User Manual

Introduction

The Océ 9400-II can be used also for digitizing analogue drawings and
uploading them to a host computer using a SCSI-2 interface. Therefore the
Scan to file option is required.
This option consists of the following parts:
Océ Scan Station software
Océ View Station software
SCSI-2 board (option) in the PC to connect the Océ 9400-II
SCSI-2 cable (option)
Making uploads
After everything has been installed correctly on the Océ 9400-II and on the PC
both systems should be connected with SCSI-2 cable and the uploading can
start, refer to 'SCSI-2' on page 25.
Switch on the Océ 9400-II and the PC.
1
Start the Upload application and set all scan parameters as required and
2
proceed as follows. (Also refer to the Océ 9400 series Scan Station manual).
As soon as the upload is started with the application, the Océ 9400-II printer
panel displays "SCANMODE" after which the system is ready to make
uploads.
Insert an original in the scanner, make the required settings on the scanner's
3
operating panel and press the Start-button on the scanner (see also notes
below).
When the original has been scanned and transported back to its start position,
4
a checkplot is made. If this has been selected to do so in the Scan Station
application. The checkplot is made on the media which has been selected on
the scanner's operating panel.
Then the Océ 9400-II controller creates the file which will be uploaded to the
5
PC.
When the file is uploaded it can be viewed on the PC.
Settings can be modified on the PC and on the scanner and a next original can
6
be scanned, or the current original can be re-scanned with the new settings.
The Upload process can be stopped on the PC and the Océ 9400 series is free
7
for print and/or copy jobs. (Also refer to the Océ 9400 series Scan Station
manual)
76 Océ 9400-II User Manual