Oce TCS400 User Manual page 71

Define the media width
Select the 'Output' card with the upper softkeys
1
Select the 'Media width' setting with the softkey for 'Media width'.
2
Select one of the following:
'Automatic'
■
The system selects an available media size based on the original width
detected by the scanner and the scale factor. Use this setting for a minimum
of loss of media.
The standard size includes the print margin. When the system detects an
original width wider than the standard format size, the output is printed on
the next larger media size. Adjust the print margin to change the standard
format size. Use the KO - Jobs - Print - Defaults - Print margin X setting
in the Océ Settings Editor to adjust the print margin.
'Roll width'
■
When the 'Scale' setting on the 'Layout' card is set to 'Automatic', 'Roll
width' fits the image to the media roll selected in the 'Media' setting.
A DIN or ANSI size.
■
Use this setting to print the output on the selected media size. When the
media size is not available, the printer shows a media request.
Available are only those the media sizes in the paper series defined in the
Note:
Océ Settings Editor.
Define the cut length
Select the 'Output' card with the upper softkeys
1
Select the 'Cut length' setting with the softkey for 'Cut length'.
2
Select one of the following:
'Synchro'
■
The length of the output is related to the length of the image.
Select 'Synchro' to prevent the loss of information.
'Standard'
■
The length of the output corresponds to a standard DIN or ANSI format,
depending on the media width.
You can select a standard cut length in landscape orientation or in portrait
orientation.
Custom.
■
The length of the output is user-defined.
Make copy jobs on the Océ TCS400 71