Oce TCS400 User Manual page 305

If for some reason you have to move the machine yourself, please make sure
■
that the mains power point has the right fuse capacity. See the Océ TCS400
safety data sheet in this appendix for information about maximum current.
Do not bridge any mechanical or electrical circuit breakers.
■
Do not use an extension lead to connect the machine.
■
This machine is not designed for connection to an IT power system. An IT
■
power system is a voltage network in which the neutral wire is not
connected to earth.
When the machine is connected through a wall socket, place the machine
■
near a wall socket that is easily accessible.
When the machine is connected through a fixed connection to the electricity
■
grid, the disconnect device in the fixed connection must be easily
accessible.
Surroundings
Make sure that the machine is placed on a level, horizontal surface of
■
sufficient strength. See the Océ TCS400 safety data sheet in this appendix
for information about the weight of the equipment.
Make sure there is sufficient space around the machine. This facilitates
■
reloading materials as well as maintenance.
Do not place the machine in rooms which are subject to excessive vibration.
■
Do not place the machine in rooms which are too small or insufficiently
■
ventilated. See the Océ TCS400 safety data sheet in this appendix for
information about space and ventilation requirements.
General
Always use materials recommended by Océ and developed for the Océ
■
TCS400. Materials not approved by Océ can cause errors in your machine.
Do not use the machine when it is emitting unusual sounds. Remove the
■
plug from the power socket or turn off the fixed connection to the electricity
grid and contact Customer Service.
This is a class A product. In a domestic environment, this product may
Note:
cause radio interference, in which case the user may be required to take
adequate measures.
Safety information 305