Oce TCS400 User Manual page 143

The screen displays feedback about the calibration process. The system does a
nozzle failure recovery.
You can stop the calibration process at any time. Press the key for 'Cancel' to
stop the calibration process.
When there are no defective printheads, you can perform a printhead
alignment. The screen displays the message 'All printheads OK. Perform
alignment?'
Press the key for 'Yes'. The system performs a printhead alignment. The screen
7
displays the message 'Aligning printheads...'
When you select 'No', the system returns to the off-line menu.
When there are printheads with defective nozzles, you cannot do a printhead
alignment. The screen displays the message 'defective printheads' with the
color and number of the defective printheads.
Press the key for 'Replace' to enter the 'Replace printhead' wizard (see 'Replace
8
a defective printhead' on page 186).
Press the key for 'Ignore' to return to the off-line screen.
When the fallback mode is disabled in the Océ Settings Editor or when
Note:
more than one printhead of one color is defective, you must replace the
defective printheads immediately.
Ensure the best quality output 143