Oce TCS400 User Manual page 138

Problem
The color of one
line runs into the
color of another
line
White stripes in
filled areas
The output color
is not the same as
the original color
The length and
width measure-
ments are differ-
ent from the
original
138 Océ TCS400 User manual
Method of Solutions
analysis
■
Quality check
print
■
■
■
■
■
Quality check
■
print
■
■
Quality check
print
■
■
■
Quality check
print
■
■
The media type defined on the printer
must be the same as the media
available on the printer. If the media
type defined on the printer is not the
same as the media available on the
printer, use the 'Change media type'
wizard to change the media type (see
'Change the type of media defined on
the printer' on page 164)
Use coated media
Use the default drying time
Use the setting KO - Printer -
Climate dependent alignment to
define if the system must
automatically do an alignment when a
large change in climate occurs.
Remove the printer from areas of high
humidity.
Use the 'Area fills' content mode
Use the 'Presentation' quality
mode(see 'Output quality and print
speed' on page 123)
Use the 'Optimize print quality'
wizard to correct the problem (see
'Use the Optimize print quality
wizard' on page 141).
Make sure you define the correct
software settings, for example the
correct pen settings.
Use the 'Area fills' content mode
Use the 'Presentation' quality mode
Make sure you defined the correct
scale settings
Use the 'Presentation' quality mode
Use the 'Optimize print quality'
wizard to correct the problem.