Oce TCS400 User Manual page 65

How to create and start a set
Place the original face down, center aligned along the measurement ruler. If
1
you feed the original, keep the original in position until it is pulled into the
scanner.
Use the numeric keys to enter the number of copies.
2
On the home screen, select the 'Entry to the copy settings'.
3
Define the job settings on the screen. Use the upper softkeys to select the
4
setting card, and the lower softkeys to define the settings in the cards.
On the 'Input mode' section of the 'Original' card, select 'Set'.
5
On the 'Media' section in the 'Output' card select the required media.
6
Press the green 'Start' key for each original of a set.
7
To close a set, press the 'Start' key without feeding an original.
When 'Auto feed' is enabled on the 'System' screen, each original after
Note:
the first original is automatically fed into the scanner. You must only press the
'Start' key after the set is complete. Make sure you first define the settings
before you feed the original.
When the original is held at the front side or the back side, use the release
8
original key on the scanner operator panel to release the original. (see 'The
scanner operator panel' on page 32).
Use the KO - Scanner - Settings - Original release mode setting in the
Note:
Océ Settings Editor to define the 'Original release mode'.
Use the home key to return to the home screen. (see 'The scanner operator
9
panel' on page 32).
Make copy jobs on the Océ TCS400 65