Use the 'Selection type' setting to define the following
6
'Delete area'
■
Delete the selected area from your output.
The area is grayed out on the output.
'Keep area'
■
Keep the selected area but delete the area that was not selected.
The complete image on the output is grayed out, except the selected area.
'Off'
■
The 'Area selection' setting is not active.
Use the settings 'Horizontal offset' and 'Vertical offset' to define the location of
7
the area.
Use the settings 'Width' and 'Length' to define the size of the area.
8
Turn the original face up to measure the offset and the size of the area.
Note:
Use the softkey for 'Back' to return to the 'Original' card.
9
Make copy jobs on the Océ TCS400
69