Press the softkey for 'Reinserted' or 'New'.
6
Select 'Reinserted' if you refit the printhead that you just removed.
Select 'New' if you replaced the original printhead.
The screen displays this message for every printhead you replaced.
To achieve optimal print quality, the system must know if the inserted
Note:
printhead is warm or cold. A reinserted printhead will be warm while a new
printhead will be cold. Always store your printheads at room temperature.
The screen displays the message 'Make sure that all head covers are properly
7
positioned.'
Press the key for 'Done'.
The screen displays the message 'Close top cover.'
Close the top cover.
8
The screen displays the message 'Carriage moving to home position...'
Press the softkey for 'Next' to start the calibration and the alignment of the
9
printheads. The screen displays 'Calibrating...'.
The calibration process takes several minutes.
You can stop the calibration process at any time. Press the key for 'Cancel' to
stop the calibration process.
When the calibration is completed, the screen displays the calibration status.
Maintenance
191