Oce TCS400 User Manual page 30

Use the upper softkeys to scroll through the wizard cards. You can select the
following wizards:
'Feed & cut'(see 'Cut the output and clean cut a roll of media' on page 161)
1
'Change media type'(see 'Change the type of media defined on the printer' on
2
page 164)
'Optimize print quality'(see 'Use the Optimize print quality wizard' on
3
page 141)
'Replace printhead'(see 'Replace a defective printhead' on page 186)
4
'Replace cassette'(see 'Replace the maintenance cassette' on page 192)
5
'Replace ink tank'(see 'Replace the ink tanks' on page 183)
6
'Display counters'
7
Select this wizard to check the amount of media and ink that is used since the
system was installed. Press the softkey for 'Finish' to return to the off-line
screen.
'Configure system'(see 'Configure the network settings of the Océ TCS400' on
8
page 49)
'Language' (switch only).
9
The screen of the off-line mode contains the following parts:
[3] The parts of the off-line screen
Part
Card
Navigation
[3] The parts of the off-line screen
30 Océ TCS400 User manual
Function
The cards show the names and a graphical representation
of the wizards.
Use the upper softkeys to navigate through the cards and
through the wizards. Use the lower softkeys to select a
card or options within the wizards.