Oce TCS400 User Manual page 142

Press the lower softkey for 'Optimize print quality' to enter the wizard.
3
An introduction screen displays the message 'Use this wizard to optimize the
print quality.' A roll must be available on the printer for use during calibration.
Press the key for 'Next'.
4
The screen displays the message 'Select roll to use'.
You can only calibrate on six defined media types (see 'Overnight printing' on
page 179). When calibration is not possible with the loaded media, the system
asks you to load the correct media. When calibration is possible with one of
the rolls, the system automatically uses the correct roll of media. When
calibration is possible with both rolls, continue with step 5.
Press the lower softkeys to select a media roll for the calibration.
5
Press the key for 'Next'.
6
The screen displays the message 'Preparing calibration...' The system prepares
for the quality check.
142 Océ TCS400 User manual