Oce TCS400 User Manual page 43

Turn the Océ Power Logic® controller and the printer off
Perform the following when the setting KO - System - Synchronize printer
and Power Logic controller power on/off if the Océ Settings Editor is set to
'On': There are two possibilities:
Press the on/off button on the printer or
1
select 'Shut down' from the 'System' menu in the Océ System Control Panel.
2
The Océ Power Logic
Perform the following when the setting KO - System - Synchronize printer
and Power Logic controller power on/off if the Océ Settings Editor is set to
'Off'.
Press the on/off button on the printer.
1
The printer shuts down.
Open the Océ System Control Panel application on the Océ Power Logic
2
controller.
From the 'System' menu, select 'Shut down'.
3
The Océ Power Logic
Turn the scanner on and off
Press the switch at the rear of the scanner.
1
The scanner begins initializing.
After the scanner initializes, this takes 3 to 5 minutes, turn the Océ Power
2
®
Logic
The scanner needs 5 minutes to warm up before you can scan a job. The
scanner needs 60 minutes to warm up for the best quality output.
Getting started
®
controller and the printer both shut down.
®
controller shuts down.
controller on.
®
43