Remote Control Codes For Integra/Onkyo Components Connected Via; Resetting Remote Mode Buttons; Resetting The Remote Controller - Integra DTR-50.1 Instruction Manual

Controlling Other Components—Continued
Remote Control Codes for Integra/
Onkyo Components Connected via
Integra/Onkyo components that are connected via
are controlled by pointing the remote controller at the
AV receiver, not the component. This allows you to con-
trol components that are out of view, in a rack, for exam-
ple.
1 Make sure the Integra/Onkyo component
is connected with an
log audio cable (RCA).
See page 40 for details.
2 Enter the appropriate remote control code
for the Remote Mode button.
• [DVD/BD] button
31612: Integra/Onkyo DVD player with
• [CD] button
71327: Integra/Onkyo CD player with
• [TV/Tape] button
42157: Onkyo cassette recorder with
(default)
• [Port] button
82351: Onkyo Dock (default)
See the previous page for how to enter remote
control codes.
3 Press the Remote Mode button, point the
remote controller at the AV receiver, and
operate the component.
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want
to control an Integra/Onkyo component that's not con-
nected via , use the following remote control codes:
• [DVD/BD] button
30627: Integra/Onkyo DVD player without
(default)
• [CD] button
71817: Integra/Onkyo CD player without
• [TV] button
11807: TV with
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, use the
following remote control codes:
32900: Integra/Onkyo BD player
32901: Integra/Onkyo HD DVD player
70868: Onkyo MD recorder
71323: Onkyo CD recorder
81993: Onkyo RI Dock with
Note:
If you connect an
TV/TAPE, or VCR/DVR, or GAME jacks, for
work properly, you must set the Input Display accord-
ingly (see page 52).
142
cable and an ana-
(default)
-capable Onkyo RI Dock to the

Resetting Remote Mode Buttons

You can reset a Remote Mode button to its default
remote control code.
1
(3 seconds)
2

Resetting the Remote Controller

You can reset the remote controller to its default settings.
1
(default)
(3 seconds)
2
to
While holding down the Remote
Mode button that you want to
reset, press and hold down the
[Audio] button until the Remote
Mode button lights up (about 3
seconds).
Within 30 seconds, press the
Remote Mode button again.
The Remote Mode button flashes
twice, indicating that the button has
been reset.
Each of the Remote Mode buttons is
preprogrammed with a remote control
code. When a button is reset, its prepro-
grammed code is restored.
Note:
The learning command is also reset.
While holding down the
[Receiver] button, press and hold
down the [Audio] button until the
Receiver button lights up (about
3 seconds).
Within 30 seconds, press the
[Receiver] button again.
The Receiver button flashes twice, indi-
cating that the remote controller has
been reset.