Table of Contents
Advertisement
First Time Setup—Continued
9
When the calculations are com-
plete, the following screen
appears.
Use the Up and Down [ ]/[ ] but-
tons to select an option, and then
press [Enter].
The options are:
Save:
Cancel:
Note:
You can view the calculated settings for
the speaker configuration, speaker dis-
tances, and speaker levels by using the
Left and Right [ ]/[ ] buttons.
10
If you selected "Save", the results are
saved, and the following screen
appears.
11
Disconnect the speaker setup
microphone.
56
MultEQ: Auto Setup
-- Review SP Configuration --
Subwoofer
No
Front
Full Band
Center
40Hz
Surround
120Hz
Front Wide
Full Band
Front High
Full Band
Surr Back
150Hz
Surr Back Ch
2ch
Save
Cancel
Save the calculated settings and exit
the room correction and speaker
setup.
Cancel the room correction and
speaker setup.
MultEQ: Auto Setup
Saving...
MultEQ: Auto Setup
Please, unplug setup microphone.
Notes:
• When the room correction and speaker setup is
complete, the "Equalizer Settings" (page 97) will be
set to "Audyssey" and "Dynamic EQ" (page 101) will
be set to "On".
• You can cancel the Room Correction and Speaker
Setup at any point in this procedure simply by
disconnecting the setup microphone.
Error Messages
While the room correction and speaker setup is in
progress, one of the following error messages may
appear:
❏ Ambient noise is too high.
MultEQ: Auto Setup
Ambient noise is too high.
Retry
Cancel
This message appears if the background noise is too
loud and the measurements cannot be performed
properly.
Remove the source of the noise and try again.
Retry: Return to the measured point immediately
before and start set up again.
Cancel: Cancel the room correction and speaker setup.
❏ Speaker Detect Error
This message appears if a speaker is not detected. "Yes"
means that a speaker was detected. "No" means that no
speaker was detected.
MultEQ: Auto Setup
Speaker Detect Error
FL
:
No
SL
:
---
FWL :
---
FHL :
---
SBL :
---
C
:
---
Retry
Cancel
The front speaker has not been detected.
MultEQ: Auto Setup
Speaker Detect Error
FL
:
Yes
SL
:
---
FWL :
Yes
FHL :
Yes
SBL :
---
C
:
Yes
Retry
Cancel
One of the front speakers has not been detected.
FR
:
---
SR :
---
FWR :
---
FHR :
---
SBR :
---
SW :
---
FR
:
No
SR :
---
FWR :
Yes
FHR :
Yes
SBR :
---
SW :
---
Hide quick links:
Advertisement
Table of Contents
