Integra DTR-50.1 Instruction Manual page 63

Basic Operations—Continued
Changing Source Component
When you want to operate the component that is not
assigned as the source component, you can assign it as
the source component. For the default assignment, see
page 151.
While holding down the Remote
Mode button, press and hold
down the [My Movie], [My TV], or
[My Music] button (about 3 sec-
onds).
The Activities buttons that you pressed
flashes twice, indicating that the setting
has been established.
Examples:
When you press the [My Music] button
and want to start the Onkyo Cassette
recorder, while holding down [TV/
Tape] button, press and hold down the
[My Music] button (about 3 seconds)
flashes twice.
(3 seconds)
Tip:
This procedure can also be performed
via onscreen menu (see page 150).
Switching Normal Macro Mode
You can switch the AV receiver to normal macro mode
from Easy macro mode, and vice versa. In the normal
macro mode, you can use macro commands (see
page 153).
While holding down the
[Receiver] button, press and hold
down the Activities buttons
(about 3 seconds).
Note:
Once the AV receiver has entered the
normal macro mode, all of the Activi-
ties buttons will automatically switch
to the Normal macro mode. In this case,
pressing the [All Off] button will only
(3 seconds)
set the AV receiver to Standby mode.
Restoring Default
1
While holding down the [Audio]
button, press and hold down the
[All Off] button until the [All Off]
button lights up (about 3 sec-
onds).
(3 seconds)
2
Release the [Audio] and [All Off]
buttons and press the [All Off]
button again.
The [All Off] button flashes twice.
63