Remote Control Codes For Integra/Onkyo Components Connected Via Ri; Resetting The Remote Mode Buttons; Resetting The Remote Controller; Controlling Other Components - Integra DTR-50.4 Instruction Manual

Remote Control Codes for
Integra/Onkyo Components Connected
via RI
Integra/Onkyo components that are connected via
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1
Make sure the Integra/Onkyo component is
connected with an cable and an analog audio
cable (RCA).
See "Connecting Integra/Onkyo RI Components" for
details (➔ page 19).
2 Enter the appropriate remote control code for a
Remote Mode button, by referring to the previous
section.
42157:
Onkyo cassette tape deck with
81993:
Onkyo Dock with
3
Press the Remote Mode button, point the remote
controller at the AV receiver, and operate the
component.
Controlling Integra/Onkyo components without
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want to
control an Integra/Onkyo component that's not connected
via , use the following remote control codes:
30627:
Integra/Onkyo DVD player without
71817:
Integra/Onkyo CD player without
32900/33100/33500:
Integra/Onkyo Blu-ray Disc player
32901/33104/33504:
Integra/Onkyo HD DVD player
70868:
Onkyo MD recorder without
71323:
Onkyo CD recorder without
82990:
are
Onkyo Dock without

Resetting the Remote Mode Buttons

You can reset a Remote Mode button to its default
remote control code.
1
While holding down the Remote Mode button that
you want to reset, press and hold down Home until
the Remote Mode button lights (about 3 seconds).
2
Within 30 seconds, press the Remote Mode button
again.
The Remote Mode button flashes twice, indicating
that the button has been reset.
Each Remote Mode button is preprogrammed with a
remote control code. When a button is reset, its
preprogrammed code is restored.
Note
• The learning command is also reset.

Resetting the Remote Controller

You can reset the remote controller to its default settings.
1
While holding down Receiver, press and hold
down Home until Receiver lights (about 3
seconds).
2 Within 30 seconds, press Receiver again.
Receiver flashes twice, indicating that the remote
controller has been reset.
En-85

Controlling Other Components

Controlling Other Components
By pressing the Remote Mode button that's been
programmed with the remote control code for your
component, you can control your component as described
below.
For details on entering a remote control code for other
components, see "Entering Remote Control Codes"
(➔ page 84).
Controlling a TV
TV is preprogrammed with the remote control code for
controlling a TV that supports the
some models). The TV must be able to receive remote
control commands via and be connected to the
AV receiver via HDMI. If controlling your TV via
doesn't work very well, program your TV's
remote control code into TV and use the TV remote mode
to control your TV.
Use the following remote control codes:
11807/13100/13500:
TV with
Controlling Apple TV
By programming the supplied remote controller with the
appropriate remote control code, you can use it to operate
your Apple TV.
Use the following remote control codes:
02615:
Apple TV
(limited to
*1