Entering Remote Control Codes; Remote Control Codes For Integra/Onkyo Components Connected Via U - Integra DTR-40.2 Instruction Manual

8
If you can control component, press Receiver,
use q/w to select "Works", and then press
Enter.
The "Remote Mode Setup" menu appears.
If you cannot control component, press
Receiver, use q/w to select "Doesn't work(Try
next code)" and press Enter.
The next code appears.
9
Press Setup.
The setup menu closes.

Entering Remote Control Codes

You'll need to enter a code for each component that you
want to control.
1
Look up the appropriate remote control code in
the separate Remote Control Codes list.
The codes are organized by category (e.g., DVD
player, TV, etc.).
2
While holding down Remote Mode to which you
want to enter a code, press and hold down Dis-
play (about 3 seconds).
The Remote Mode button lights.
Note
• Remote control codes cannot be entered for Receiver
and Zone2.
• Only TV remote control codes can be entered for TV.
• Except for Receiver, TV and Zone2, remote control
codes from any category can be entered as Remote
Mode. However, these buttons also work as input selector
buttons (➔ 25), so choose a Remote Mode that corre-
sponds with the input to which you connect your compo-
nent. For example, if you connect your CD player to the
CD input, choose TV/CD when entering its remote control
code.
3
Within 30 seconds, use the number buttons to
enter the 5-digit remote control code.
Remote Mode button flashes twice.
If the remote control code is not entered success-
fully, Remote Mode button will flash once slowly.
Note
• The remote control codes provided are correct at the time of
printing, but are subject to change.
En
88
Remote Control Codes for Integra/
Onkyo Components Connected via u
Integra/Onkyo components that are connected via u are
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1
Make sure the Integra/Onkyo component is con-
nected with an u cable and an analog audio
cable (RCA).
See "Connecting Integra/Onkyo u Components"
20).
for details (➔
2
Enter the appropriate remote control code for
Remote Mode.
• BD/DVD

31612:
Integra/Onkyo DVD player with u
• TV/CD

71327:
Integra/Onkyo CD player with u

42157:
Onkyo cassette tape deck with u
• Port

81993:
Onkyo Dock with u
See the previous section for how to enter remote
control codes.
Note
• When using a cassette tape deck connected via u, press
and hold TV/CD to switch to TAPE.
3
Press Remote Mode, point the remote controller
at the AV receiver, and operate the component.
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want to
control an Integra/Onkyo component that's not connected
via u, use the following remote control codes:
• BD/DVD
30627:
Integra/Onkyo DVD player without u
• TV/CD
71817:
Integra/Onkyo CD player without u
11807:
TV with p