Integra DTR-50.1 Instruction Manual page 73

Listening to the Radio—Continued
8 When you've finished, press
[Enter] to save your changes, or
press [Return] to return to the
previous screen without saving.
When [Enter] is pressed, the confirma-
tion message "Locked" or "Unlocked"
appears.
9
Press the [Setup] button.
The setup menu closes.
Notes:
• While a channel is locked, it cannot be selected for
listening.
• To unlock a channel, you must enter the correct PIN
number and change it to Unlocked in step 6.
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
Changing the PIN Number
Enter
Setup
1 Press the [Receiver] button, fol-
lowed by the [Setup] button.
Remote
The main menu appears onscreen.
controller
2
3
4
Receiver
Use the Up and Down [ ]/[ ] but-
tons to select "7. Hardware
Setup", and then press [Enter].
The "Hardware Setup" menu appears.
7. Hardware Setup
1. Remote ID
2. Multi Zone
3. Tuner
4. HDMI
5. Network
6. Firmware Update
Use the Up and Down [ ]/[ ] but-
tons to select "3. Tuner", and
then press [Enter].
The "Tuner" screen appears.
7–3. Tuner
FM/AM Frequency Step 200kHz/10kHz
SAT Radio Mode SIRIUS
Antenna Aiming
SIRIUS Parental Lock
Use the Up and Down [ ]/[ ] but-
tons to select "SIRIUS Parental
Lock", and then press [Enter].
The "SIRIUS Parental Lock" screen
appears.
SIRIUS Parental Lock
Enter Code
0 1 2 3 4 5 6 7 8
Note:
If the "SAT Radio Mode" is set to
"None" (see page 67), the "SIRIUS
Parental Lock" item is not available.
9
73