Changing The Input Display - Integra DTR-50.1 Instruction Manual

First Time Setup—Continued
3 Use the Up and Down [ ]/[ ] but-
tons to select "3. Tuner", and
then press [Enter].
The "Tuner" menu appears.
(North American models)
(Australian models)
4 Use the Left and Right [ ]/[ ]
buttons to select:
(North American models)
200kHz/10kHz:
50kHz/9kHz:
(Australian models)
10kHz: Select if 10 kHz steps are
9kHz: Select if 9 kHz steps are used
5
Press the [Setup] button.
The setup menu closes.
Note:
This procedure can also be performed on the AV receiver
by using its [Setup] button, arrow buttons, and [Enter]
button.

Changing the Input Display

If you connect an
recorder, CD recorder, or RI Dock to the TV/TAPE IN/
OUT jacks, or connect an RI Dock to the GAME IN or
VCR/DVR IN jacks, for
change this setting.
This setting can only be changed on the AV receiver.
52
7–3. Tuner
FM/AM Frequency Step 200kHz/10kHz
SAT Radio Mode None
7–3. Tuner
AM Frequency Step 9kHz
Select if 200 kHz/10 kHz steps are
used in your area.
Select if 50 kHz/9 kHz steps are
used in your area.
used in your area.
in your area.
-capable Onkyo MiniDisc
to work properly, you must
VCR/DVR TV/ Tape
Game
1 Press the [TV/Tape], [Game] or
[VCR/DVR] input selector button
so that "TV/TAPE", "GAME" or
"VCR/DVR" appears on the dis-
play.
or
or
2
Press and hold down the [TV/
Tape], [Game] or [VCR/DVR]
input selector button (about 3
seconds) to change the setting.
Repeat this step to select MD, CDR, or
DOCK.
or
For the TV/Tape input selector, the
setting changes in this order:
TV/TAPE
DOCK
For the Game input selector, the setting
or
changes in this order:
↔
GAME
For the VCR/DVR input selector, the
setting changes in this order:
VCR/DVR
(3 seconds)
Notes:
• DOCK can be selected for the TV/Tape or Game or
VCR/DVR input selector, but not at the same time.
• Enter the appropriate remote control code before
using the AV receiver's remote controller for the first
time (see page 141).
→ →
MD CDR
→
DOCK
↔
DOCK