Turning On The Av Receiver; Turning On And Standby - Integra DTR-50.1 Instruction Manual

Turning On the AV receiver

On/Standby
Standby indicator

Turning On and Standby

AV receiver Remote
controller
or
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here's a few easy steps to help you configure the AV receiver before you use it for the
very first time. These settings only need to be made once.
■ Did you connect your TV to an HDMI output or COMPONENT VIDEO MONITOR OUT?
If you did, "Monitor Setup" on page 42.
■ Run MultEQ Room Correction and Speaker Setup—this is essential!
See "Audyssey MultEQ
■ Have you connected a component to an HDMI input,
component video input, or digital audio input?
If you have, see "HDMI Input Setup" on page 47, "Component Video
Input Setup" on page 48, or "Digital Audio Input Setup" on page 49
respectively.
■ Have you connected an Integra/Onkyo MD recorder, CD
recorder, or RI Dock?
If you have, see "Changing the Input Display" on page 52.
On the AV receiver, press the [On/Standby] button.
On the remote controller, press the [Receiver] button, followed by the
[On] button.
The AV receiver comes on, the display lights up, and the Standby indicator goes off.
Pressing the remote controller's [On] button again will turn on any components
connected via .
To turn the AV receiver off, press the [On/Standby] button, or press the remote
controller's [Standby] button. The AV receiver will enter Standby mode. To prevent any
loud surprises when you turn on the AV receiver, always turn down the volume before
you turn it off.
®
Room Correction and Speaker Setup" on page 53.
Standby
On
Receiver
HDMI
OUT IN
MD recorder, CD recorder,
TV/TAPE
RI Dock
41