Integra DTR-50.1 Instruction Manual page 114

Advanced Setup—Continued
Power Control
To link the power functions of
This setting is set to "On" automatically when the above "HDMI Control (RIHD)" is set to "On" for the first time.
Notes:
• The
"Power Control"
• HDMI power control only works with
properly with some components due to their settings or compatibility.
• When set to "On", the power consumption on standby mode increases.
• When set to "On", regardless of whether the AV receiver is On or on Standby, both audio and video received
by an HDMI input will be output by the HDMI output for playback on the TV or other component that's
connected to the HDMI output.
• Refer to the connected component's instruction manual for details.
TV Control
Set to "On" when you want to control the AV receiver from an
HDMI.
Notes:
• Do not assign the component connected with the HDMI input to the TV/Tape selector when you set "TV
Control" setting to "On". Otherwise, appropriate CEC (Consumer Electronics Control) operation is not guar-
anteed.
• Set to Off
"
• The
"TV Control"
settings are both set to "On".
• Refer to the connected component's instruction manual for details.
Note:
After changing the settings of the
nected pieces of equipment to Standby and then turn them on again. Refer to the User's Manuals for all
connected pieces of equipment.
Network
See "Network Settings" on page 125.
Firmware Update
Notes:
• Perform the firmware update only when an announcement is posted on the Integra Web site.
• It takes about 40 minutes to complete the firmware update.
Version
The current version of the firmware is displayed. The version is made up of the versions of the AV receiver and
Onkyo dock (if connected).
Receiver
You can update the AV receiver's firmware. Do not shutdown the power of the AV receiver while update.
Universal Port
You can update the Onkyo dock's firmware. Do not shutdown the power of the AV receiver while update.
Note:
This update shall not be performed when no dock is connected to UNIVERSAL PORT jack.
114
On: Power Control enabled.
Off: Power Control disabled.
setting can be set only when the above
On: TV Control enabled.
Off: TV Control disabled.
when the TV is not compatible or when it is unclear whether the TV is compatible or not.
"
setting can be set only when the above
" HDMI Control (RIHD)
via NET: You can update the firmware via Internet. Check the network connection
before update.
via USB: You can update the firmware from a USB mass storage device.
via NET: You can update the firmware via Internet. Check the network connection
before update.
via USB: You can update the firmware from a USB mass storage device.
-compatible components connected via HDMI, select "On".
HDMI Control (RIHD)
"
-compatible components that support it and may not work
HDMI Control (RIHD)
"
" , "Power Control"
setting is set to "On".
"
-compatible TV that is connected to
and
" "Power Control"
, or "TV Control" , set all con-