Remote Control Codes For Integra/Onkyo Components Connected Via; Resetting Remote Mode Buttons; Resetting The Remote Controller; Controlling Other Components - Integra DTR-40.3 Instruction Manual

Remote Control Codes for Integra/Onkyo
Components Connected via
Integra/Onkyo components that are connected via
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1
Make sure the Integra/Onkyo component is
connected with an
cable (RCA).
See "Connecting Integra/Onkyo
for details (➔ page 20).
2
Enter the appropriate remote control code for
Remote Mode, referring to the previous section.
42157:
Onkyo cassette tape deck with
81993:
Onkyo Dock with
3 Press Remote Mode, point the remote controller
at the AV receiver, and operate the component.
Controlling Integra/Onkyo components without
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want to
control an Integra/Onkyo component that's not connected
via , use the following remote control codes:
30627:
Integra/Onkyo DVD player without
71817:
Integra/Onkyo CD player without
32900/33100/33500:
Integra/Onkyo Blu-ray Disc player
32901/33104/33504:
Integra/Onkyo HD DVD player
70868:
Onkyo MD recorder without
71323:
Onkyo CD recorder without
82990:
Onkyo Dock without

Resetting REMOTE MODE Buttons

You can reset a Remote Mode to its default remote
control code.
1
While holding down Remote Mode that you want
to reset, press and hold down Home until Remote
Mode button lights (about 3 seconds).
En
72
are
cable and an analog audio
Components"
2
Within 30 seconds, press Remote Mode again.
Remote Mode button flashes twice, indicating that
the button has been reset.
Each of Remote Mode is preprogrammed with a
remote control code. When a button is reset, its
preprogrammed code is restored.
Note
• The learning command is also reset.

Resetting the Remote Controller

You can reset the remote controller to its default settings.
1
While holding down Receiver, press and hold
down Home until Receiver lights (about 3
seconds).
2 Within 30 seconds, press Receiver again.
Receiver flashes twice, indicating that the remote
controller has been reset.

Controlling Other Components

By pressing the Remote Mode that's been programmed
with the remote control code for your component, you can
control your component as described below.
For details on entering a remote control code for other
components, see "Entering Remote Control Codes"
(➔ page 71).
Controlling a TV
TV is preprogrammed with the remote control code for
controlling a TV that supports the
some models). The TV must be able to receive remote
control commands via
AV receiver via HDMI. If controlling your TV via
doesn't work very well, program your TV's
remote control code into TV and use the TV remote mode
to control your TV.
Use the following remote control codes:
11807/13100/13500:
TV with
Controlling a Blu-ray Disc/DVD Player, HD
DVD Player or DVD Recorder
BD/DVD is preprogrammed with the remote control code
for controlling a component that supports the
(limited to some models). The component must be able to
receive remote control commands via
connected to the AV receiver via HDMI.
Use the following remote control codes:
32910/33101/33501/31612:
Blu-ray Disc/DVD player with
*1 The supported by the AV receiver is the CEC
system control function of the HDMI standard.
(limited to
*1
and be connected to the
*1
and be