Integra DTR-50.1 Instruction Manual page 27

Connecting the AV receiver—Continued
■ "Monitor Out" Setting Set to "Both", "Both(Main)" or "Both(Sub)"
With the "Monitor Out" setting set to "Both",
"Both(Main)" or "Both(Sub)" (see page 42),
video input signals flow through the AV receiver
as shown, with composite video, S-Video, and
component video sources all being upconverted
for both HDMI outputs. Use the "Both",
"Both(Main)" or "Both(Sub)" setting if you
connect the AV receiver's HDMI OUT MAIN
and HDMI OUT SUB to your TVs.
The composite video, S-Video, and component
video outputs pass through their respective input
signals as they are.
Both: Video signals are output from both HDMI
outputs at the resolution supported by both TVs.
You cannot select "Resolution" setting. The
"Picture Adjust" setting will be that for "HDMI
Main".
Both (Main): Video signals are output from both
HDMI outputs but HDMI OUT MAIN will become a priority; depending on the resolution, video signals may not be
output from HDMI OUT SUB.
Both (Sub): Video signals are output from both HDMI outputs but HDMI OUT SUB will become a priority; depending
on the resolution, video signals may not be output from HDMI OUT MAIN.
Note:
The "Monitor Out" setting will be automatically switched to "Analog" if not connected to both outputs when "Both" is
selected or if not connected to a priority output when "Both(Main)" or "Both(Sub)" is selected.
■ "Monitor Out" Setting Set to "Analog"
With the "Monitor Out" setting set to "Analog"
(see page 42), video input signals flow through
the AV receiver as shown, with composite video
and S-Video sources being upconverted for the
component video output. Use this setting if you
connect the AV receiver's COMPONENT
VIDEO MONITOR OUT to your TV.
Composite video is upconverted to S-Video and
S-Video is downconverted to composite video.
Note that these conversions only apply to the
MONITOR OUT V and S outputs, not the
VCR/DVR OUT V and S outputs.
The composite video, S-Video, and component
video outputs pass through their respective input
signals as they are.
This signal flow also applies when the "Resolu-
tion" setting is set to "Through" (see page 46).
Video Signal Flow and the Resolution Setting
When the "Monitor Out" setting is set to "Ana-
log" (see page 42), if the "Resolution" setting is
set to anything other than "Through"
(see page 46), the video signal flow will be as
shown here, with composite video and S-Video
sources being upconverted for the component
video output.
The composite video, S-Video, and component
video outputs pass through their respective ana-
log input signals as they are. HDMI input signals
are not output.
DVD/BD player, etc. Video Signal Flow Chart
Composite
AV receiver
Composite
TV, projector, etc.
DVD/BD player, etc. Video Signal Flow Chart
Composite
AV receiver
Composite
TV, projector, etc.
DVD/BD player, etc. Video Signal Flow Chart
Composite
AV receiver
Composite
TV, projector, etc.
S-Video Component HDMI
IN
MONITOR OUT
Component HDMI
S-Video
S-Video Component HDMI
IN
MONITOR OUT
Component HDMI
S-Video
S-Video Component HDMI
IN
MONITOR OUT
Component
HDMI
S-Video
27