Integra DTR-50.1 Instruction Manual page 159

Troubleshooting—Continued
Important Note Regarding Video Playback
The AV receiver can upconvert component video, S-
Video, and composite video sources for display on a TV
connected to the HDMI OUT. However, if the picture
quality of the source is poor, upconversion may make the
picture worse or disappear altogether.
In this case, try the following:
1 If the video source is connected to a component
video input, connect your TV to the
COMPONENT VIDEO MONITOR OUT.
If the video source is connected to an S-Video input,
connect your TV to a MONITOR OUT S.
If the video source is connected to a composite video
input, connect your TV to the MONITOR OUT V.
2 On the main menu, select "1. Input/Output
Assign", and then select "2. HDMI Input".
Select the relevant input selector, and assign it to
"- - - - -" (page 47).
3 On the main menu, select "1. Input/Output
Assign", and then select "3. Component Video
Input" (page 48).
If the video source is connected to COMPONENT
VIDEO IN1, select the relevant input selector, and
assign it to "IN1".
If the video source is connected to COMPONENT
VIDEO IN2, select the relevant input selector, and
assign it to "IN2".
If the video source is connected to COMPONENT
VIDEO IN3, select the relevant input selector, and
assign it to "IN3".
If the video source is connected to an S-Video input
or composite video input, select the relevant input
selector, and assign it to "- - - - -".
Note :
If "Monitor Out" setting is set to "Analog", press [VCR/
DVR] and [Return] buttons on the AV receiver at the
same time. Select "Skip" in the "VideoProcessor" setting
on the display. To reset back to the original setting, press
the same button at the same time. If you select "Use", the
AV receiver will output video signals from the video pro-
cessor.
159