Integra DTR-50.1 Instruction Manual page 111

Advanced Setup—Continued
Remote ID
Remote ID 1, 2, 3
When several Integra/Onkyo components are used in the same room, their remote ID codes may overlap. To
differentiate the AV receiver from the other components, you can change its remote ID from 1, the default, to
2 or 3.
Changing the Remote Controller's ID
1
While holding down the [Receiver] button, press and hold down the [Setup] button until
the Receiver button lights up (about 3 seconds).
2 Use the number buttons to enter ID 1, 2, or 3.
The Receiver button flashes twice.
Note:
If you do change the AV receiver's remote ID, be sure to change the remote controller to the same ID, otherwise,
you won't be able to control it with the remote controller.
Multi Zone
See "Setting the Multi Zone" on page 134.
Tuner
FM/AM Frequency Step (North American models)
AM Frequency Step (Australian models)
See "FM/AM Frequency Step Setup" on page 51.
SAT Radio Mode (North American models)
If you connect a SIRIUS Satellite Radio antenna to the AV receiver (sold separately), set this setting to "SIR-
IUS". See "Setting the Satellite Radio Mode" on page 67.
Antenna Aiming (North American models)
The ID of the Sirius Connect Home Tuner is displayed here. You must sign up to obtain a SIRIUS ID.
See "Positioning the SiriusConnect Home Antenna" on page 75.
SIRIUS Parental Lock (North American models)
This item is for use with SIRIUS Satellite Radio. It's not available if "SAT Radio Mode" is set to "None".
See "SIRIUS Parental Lock" on page 71.
HDMI
Audio TV Out
This preference determines whether audio received at the HDMI IN is output by the HDMI OUT. You may
want to turn this preference on if your TV is connected to the HDMI OUT and you want to listen to the audio
from a component that's connected to an HDMI IN, through your TV's speakers. Normally, this should be set
to "Off".
Off: HDMI audio is not output to TV (default).
On: HDMI audio is output to TV and the sound will be heard from the TV
speakers.
111