Srx240 Services Gateway Mini-Physical Interface Modules; Mini-Physical Interface Modules For The Srx240 Services Gateway - Juniper SRX240 Hardware Manual

CHAPTER 3
SRX240 Services Gateway Mini-Physical
Interface Modules

Mini-Physical Interface Modules for the SRX240 Services Gateway

Related
Documentation
Copyright © 2013, Juniper Networks, Inc.
This chapter includes the following topic:
Mini-Physical Interface Modules for the SRX240 Services Gateway on page 23
SRX240 Services Gateway support Mini-Physical Interface Modules (Mini-PIMs).
A Mini-PIM is a network interface card (NIC) that is installed on the services gateways
to provide physical connections to a LAN or a WAN. The Mini-PIM receives incoming
packets from the network and transmits outgoing packets to the network.
The Mini-PIMs supported on SRX240 Services Gateways are field-replaceable—you can
remove and replace them. You can install a Mini-PIM in the Mini-PIM slots on the front
panel of the services gateway chassis.
CAUTION: The Mini-PIMs for SRX240 Services Gateways are not
hot-swappable. You must power off the services gateway before removing
or installing Mini-PIMs.
For more information about supported Mini-PIMs, and on how to install and configure
Mini-PIMs, refer to the
SRX Series Services Gateways for the Branch Physical Interface
Modules Hardware Guide
SRX240 Services Gateway Chassis on page 7
SRX240 Services Gateway Front Panel and Back Panel Views on page 9
SRX240 Services Gateway LEDs on page 14
SRX240 Services Gateway Built-In Interfaces on page 12
SRX240 Services Gateway Cooling System on page 21
23