Resetting The Srx240 Services Gateway; Connecting The Srx240 Services Gateway Dc Power Supply Model To A Dc Power Source; Connecting And Organizing Interface Cables To The Srx240 Services - Juniper SRX240 Hardware Manual

Resetting the SRX240 Services Gateway

Related
Documentation
Copyright © 2013, Juniper Networks, Inc.
Chapter 10: Connecting, Grounding, and Powering On the SRX240 Services Gateway
For more information about halting, powering off, or rebooting the services gateway using
the CLI, see the following guides:
Initial Configuration for Security Devices
Monitoring and Troubleshooting for Security Devices
The RESET CONFIG button located at the front panel of the SRX240 Services Gateway
removes the current configuration and resets the device to the default configuration. The
button is recessed in the front panel to prevent it from being pressed accidentally.
NOTE: Pressing and holding the RESET CONFIG button for 15 seconds or
more deletes all configurations on the device and loads and commits the
factory configuration.
Required Tools and Parts for Installing and Maintaining the SRX240 Services Gateway
on page 39
Connecting and Organizing Interface Cables to the SRX240 Services Gateway on
page 54
Connecting the SRX240 Services Gateway to the AC Power Source on page 49
Connecting the SRX240 Services Gateway DC Power Supply Model to a DC Power
Source on page 50
59