Copper Conductors Warning - Juniper SRX240 Hardware Manual

Related
Documentation
Copyright © 2013, Juniper Networks, Inc.
Other countries—International Electromechanical Commission (IEC) 60364, Part 1
through Part 7
Evaluated to the TN power system
Locate the emergency power-off switch for the room in which you are working so that
if an electrical accident occurs, you can quickly turn off the power.
Do not work alone if potentially hazardous conditions exist anywhere in your workspace.
Never assume that power is disconnected from a circuit. Always check the circuit before
starting to work.
Carefully look for possible hazards in your work area, such as moist floors, ungrounded
power extension cords, and missing safety grounds.
Operate the services gateway within marked electrical ratings and product usage
instructions.
For the services gateway and peripheral equipment to function safely and correctly,
use the cables and connectors specified for the attached peripheral equipment, and
make certain they are in good condition.

Copper Conductors Warning

WARNING: Use copper conductors only.
Waarschuwing Gebruik alleen koperen geleiders.
Varoitus Käytä vain kuparijohtimia.
Attention Utilisez uniquement des conducteurs en cuivre.
Warnung Verwenden Sie ausschließlich Kupferleiter.
Avvertenza Usate unicamente dei conduttori di rame.
Advarsel Bruk bare kobberledninger.
Aviso Utilize apenas fios condutores de cobre.
¡Atención! Emplee sólo conductores de cobre.
Varning! Använd endast ledare av koppar.
SRX240 Services Gateway Definition of Safety Warning Levels on page 109
SRX240 Services Gateway General Safety Guidelines and Warnings on page 111
SRX240 Services Gateway Fire Safety Requirements on page 115
SRX240 Services Gateway Installation Safety Guidelines and Warnings on page 116
SRX240 Services Gateway Laser and LED Safety Guidelines and Warnings on page 121
Appendix A: Safety and Regulatory Compliance Information
131