Maintaining The Srx240 Services Gateway Hardware Components - Juniper SRX240 Hardware Manual

CHAPTER 14
Maintaining the SRX240 Services
Gateway Hardware Components

Maintaining the SRX240 Services Gateway Hardware Components

Copyright © 2013, Juniper Networks, Inc.
This chapter includes the following topics:
Maintaining the SRX240 Services Gateway Hardware Components on page 89
Replacing the Air Filter on the SRX240 Services Gateway on page 90
Table 31 on page 89 describes the common tasks to maintain the hardware components
of the services gateway.
Table 31: Maintenance Procedures for the Services Gateway Hardware
Components
Maintenance Procedures
Routine Maintenance Procedures
Maintaining the Cooling System
Description
To maintain optimum performance of the services
gateway, you must regularly perform the following
preventive maintenance procedures:
Inspect the installation site for moisture, loose wires
or cables, and excessive dust.
Ensure that airflow is unobstructed around the
device and into the air intake vents.
Check the Status LED on the front panel of the
device and on the Mini-Physical Interface Module
(Mini-PIM) you are using.
The services gateway cooling system works to
maintain an optimal temperature for the device. If the
fan controller fails, the device temperature will exceed
the maximum working temperature and the device
will fail. Ensure that you maintain the recommended
clearances behind the device to enable the cooling
system to function optimally.
89