Installing The Srx240 Services Gateway; Srx240 Services Gateway Safety Requirements, Warnings, And Guidelines; Preparing The Srx240 Services Gateway For Installation - Juniper SRX240 Hardware Manual

CHAPTER 9

Installing the SRX240 Services Gateway

SRX240 Services Gateway Safety Requirements, Warnings, and Guidelines

Related
Documentation

Preparing the SRX240 Services Gateway for Installation

Copyright © 2013, Juniper Networks, Inc.
This chapter includes the following topics:
SRX240 Services Gateway Safety Requirements, Warnings, and Guidelines on page 43
Preparing the SRX240 Services Gateway for Installation on page 43
Installing the SRX240 Services Gateway on page 44
Replacing or Installing Mini-Physical Interface Modules in the SRX240 Services
Gateway on page 47
To avoid harm to yourself or the device as you install and maintain it, follow the guidelines
for working with and near electrical equipment, as well as the safety procedures for
working with devices. For a discussion of how to make the installation site a safe
environment along with a list of safety warnings, see Appendix A, Safety and Regulatory
Compliance Information.
NOTE: Providing an exhaustive set of guidelines for working with electrical
equipment is beyond the scope of this guide.
Preparing the SRX240 Services Gateway for Installation on page 43
Installing the SRX240 Services Gateway on page 44
You can mount an SRX240 Services Gateway in a rack. The services gateway can be
mounted on four-post (telco) racks, enclosed cabinets, and open-frame racks.
Table 23: SRX240 Services Gateway Preinstallation Checklist
Task
Verify that the installation site meets the
requirements.
Additional Information
"General Site Guidelines for Installing the SRX240
Services Gateway" on page 32
43