Monitoring The Srx240 Services Gateway Components Using Leds - Juniper SRX240 Hardware Manual

Related
Documentation

Monitoring the SRX240 Services Gateway Components Using LEDs

Copyright © 2013, Juniper Networks, Inc.
1 alarms currently active
Alarm time
2010-01-04 17:11:06 UTC
For more information, see the following guides:
Initial Configuration for Security Devices
Monitoring and Troubleshooting for Security Devices
Monitoring the SRX240 Services Gateway Components Using LEDs on page 97
Monitoring the SRX240 Services Gateway Using Chassis Alarm Conditions on page 101
Monitoring the SRX240 Services Gateway Power System on page 103
The LEDs on the services gateway display the status of various components.
Table 32 on page 97 describes the LEDs.
Table 32: Component LEDs on the SRX240 Services Gateway
LED State
Status LED Green
Yellow
Red
Chapter 15: Monitoring the SRX240 Services Gateway
Class Description
Minor Host 0 Boot firmware requires upgrade
Meaning
The services gateway is
functioning normally.
The services gateway is
starting up.
The RESET CONFIG
button is pressed.
An error is detected in the
services gateway.
Possible Causes and
Corrective Actions
Normal condition. No action
is required.
Normal condition. No action
is required.
Contact the Juniper
Networks Technical
Assistance Center (JTAC).
See "Juniper Networks
Technical Assistance
Center" on page 106.
97