Juniper SRX210HE2 Quick Start Manual

SRX210 Services Gateway Quick Start
Use the instructions in this quick start to help you connect the SRX210 Services
Gateway to your network. For details, see the SRX210 Services Gateway Hardware
Guide at
http://www.juniper.net/techpubs/en_US/release-independent/junos/information-products/p
athway-pages/srx-series/product/index.html.
SRX210 Services Gateway Front Panel
2 3 4 5 6
Callout Description
1 Mini-PIM slot
2 Power button
3 LEDs: ALARM, POWER, STATUS,
HA, mPIM, EXPCARD
4 RESET CONFIG button
SRX210 Services Gateway Back Panel
1 2 3 4
Callout Description
1 Power supply input
2 Cable tie holder
3 Grounding point
1
7
Callout Description
5 USB ports
6 Console port
7 Gigabit Ethernet (0/0 and 0/1) and Fast
Ethernet (0/2 to 0/7) ports
5
Callout Description
4 Lock for security cable
5 ExpressCard slot
SRX210 Services Gateway Models
The following models of SRX210 Services Gateways are available:
Device DDR Memory
SRX210HE2 2 GB
SRX210HE2-POE 2 GB
On the SRX210HE2-POE model, Power over Ethernet (PoE) of 50 watts is supported
across four ports (0/0, 0/1, 0/2, and 0/3).
Note that you must use the following power supply adapters (supplied) for your services
gateway:
54V, 200 watts power supply adapters for the PoE model

12V, 60 watts power supply adapters for the non-PoE model

Connecting and Configuring the SRX Series Device
Use the instructions below to connect and set up the SRX210 Services Gateway to
protect your network. Refer to the LEDs on the front of the device to help you determine
the status of the device.
Overview
The SRX210 Services Gateway requires these basic configuration settings to function
properly:
Interfaces must be assigned IP addresses.

Interfaces must be bound to zones.

Policies must be configured between zones to permit or deny traffic.

Source NAT rules must be set.

The device has the following default configuration set when you power it on for the first
time. To use the device, you do not need to perform any initial configuration.
Factory-Default Settings:
Port Label Interface Security Zone
0/0 ge-0/0/0 untrust
0/1 and 0/2 ge-0/0/1 and trust
to 0/7 fe-0/0/2 to
fe-0/0/7
NAND Flash Memory
2 GB
2 GB
DHCP State IP Address
client unassigned
server 192.168.1.1/24