Conditions - Juniper SRX240 Hardware Manual

Related
Documentation
Monitoring the SRX240 Services Gateway Using Chassis Alarm Conditions
Copyright © 2013, Juniper Networks, Inc.
Monitoring the SRX240 Services Gateway Chassis Using the CLI on page 95
Monitoring the SRX240 Services Gateway Using Chassis Alarm Conditions on page 101
Monitoring the SRX240 Services Gateway Power System on page 103
Loading the Rescue Configuration on the SRX240 Services Gateway on page 105
Changing the RESET CONFIG Button Behavior on the SRX240 Services Gateway on
page 106
Juniper Networks Technical Assistance Center on page 106
When the services gateway detects an alarm condition, the Alarm LED on the front panel
turns red or yellow as appropriate.
To view a more detailed description of the cause of the alarm, issue the
CLI command.
alarms
For more information about the
Initial Configuration for Security Devices
Monitoring and Troubleshooting for Security Devices
Table 33 on page 101 describes the chassis alarm conditions and corrective actions.
Table 33: SRX240 Services Gateway Chassis Alarm Conditions and
Corrective Actions
Component Alarm Condition
Boot media The services
gateway boots from
an alternate boot
device.
Chapter 15: Monitoring the SRX240 Services Gateway
show chassis alarms command, see the following guides:
Action
If the internal flash memory fails at startup,
the services gateway automatically boots
itself from the alternative boot device
(USB storage device).
NOTE: If you configured your services
gateway to boot from an alternative boot
device, ignore this alarm condition.
Reformat the internal flash memory and
install a bootable image. (See the
Configuration for Security Devices
If you did not configure the services
gateway to boot from an alternative boot
device, contact Juniper Networks Technical
Assistance Center (JTAC). See
Networks Technical Assistance Center" on
page 106.
show chassis
Alarm
Severity
Yellow
(minor)
Initial
..)
"Juniper
101