Gateway; Srx240 Services Gateway Software Configuration Overview; Preparing The Srx240 Services Gateway For Configuration - Juniper SRX240 Hardware Manual

CHAPTER 13
Performing Initial Software Configuration
on the SRX240 Services Gateway

SRX240 Services Gateway Software Configuration Overview

Preparing the SRX240 Services Gateway for Configuration

Copyright © 2013, Juniper Networks, Inc.
This chapter includes the following topics:
SRX240 Services Gateway Software Configuration Overview on page 71
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
Setup Wizard on page 75
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
CLI on page 78
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
J-Web Interface on page 80
SRX240 Services Gateway Secure Web Access Overview on page 85
This topic includes the following sections:
Preparing the SRX240 Services Gateway for Configuration on page 71
Understanding the Factory Default Configuration on page 72
Understanding Built-In Ethernet Ports and Initial Configuration on page 72
Mapping the Chassis Cluster Ports on page 73
Understanding Management Access on page 74
The services gateway is shipped with the Juniper Networks Junos operating system (Junos
OS) preinstalled. When the services gateway is powered on, it is ready to be configured.
You can perform the initial configuration of the services gateway by using the
browser-based setup wizard or by using the command-line interface (CLI).
Before configuring the services gateway, gather the configuration information required
to deploy the services gateway in your network. At minimum, the setup wizard requires
the following information:
Device name to be used on the network
71