Power Source - Juniper SRX240 Hardware Manual

SRX240 Services Gateway Hardware Guide
Related
Documentation
Connecting the SRX240 Services Gateway DC Power Supply Model to a DC Power
Source
50
To connect the device to the power supply:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the other end of the ESD strap to the ESD point on the rack.
Insert the appliance coupler end of a power cord into the appliance inlet on the power
2.
supply faceplate.
Insert the plug into an AC power source receptacle.
3.
NOTE: The services gateway must be connected to earth ground during
normal operation. The protective earthing terminal on the rear of the chassis
is provided to connect the services gateway to ground.
CAUTION: We recommend using a surge protector for the power connection.
NOTE: Use the cable tie holder to secure the power cord on to the power
supply point.
NOTE: We strongly recommend that you use only the 3-prong power cord
supplied with your services gateway. If you are using a 2-prong power cord,
then ensure that your services gateway is adequately grounded using the
grounding point available on the back panel of the chassis.
Installing the SRX240 Services Gateway on page 44
Required Tools and Parts for Installing and Maintaining the SRX240 Services Gateway
on page 39
Connecting and Organizing Interface Cables to the SRX240 Services Gateway on
page 54
Grounding the SRX240 Services Gateway on page 55
Powering On and Powering Off the SRX240 Services Gateway on page 57
WARNING: DC-powered SRX240 Services Gateways are intended for
installation only in a restricted access location.
Copyright © 2013, Juniper Networks, Inc.