Gateway - Juniper SRX240 Hardware Manual

SRX240 Services Gateway Hardware Guide
Related
Documentation
Connecting the Modem to the Console Port on the SRX240 Services Gateway
Related
Documentation
68
Disable flow control by entering
8.
Save modem settings by entering
9.
Connecting to the SRX240 Services Gateway Setup Wizard on page 63
Connecting the SRX240 Services Gateway to the CLI on page 64
Connecting to the CLI at the User End for the SRX240 Services Gateway on page 69
Connecting the Modem to the Console Port on the SRX240 Services Gateway on
page 68
To connect the dial-up modem to the console port on the services gateway:
Turn off power to the services gateway.
1.
Turn off power to the modem.
2.
Plug one end of the Ethernet cable supplied with your services gateway into the
3.
console port.
Plug the other end of the CAT-5e (Ethernet cable) into the RJ-45 to DB-9 serial port
4.
adapter supplied with your services gateway.
Connect the serial port adapter to a separately purchased DB-9 female to DB-25
5.
male adapter or other adapter appropriate for your modem.
Plug the modem adapter into the DB-25 connector on the modem.
6.
Connect the modem to your telephone network.
7.
Turn on the power to the modem.
8.
Power on the services gateway by pressing the Power button on the front panel. Verify
9.
that the Power LED on the front panel turns green.
NOTE: Most modems have an RS-232 DB-25 connector. You must
separately purchase an adapter to connect your modem to the RJ-45 to
DB-9 adapter and Ethernet cable supplied with the services gateway.
Connecting to the SRX240 Services Gateway Setup Wizard on page 63
Connecting the SRX240 Services Gateway to the CLI on page 64
Connecting the Modem at the SRX240 Services Gateway End on page 67
Connecting to the CLI at the User End for the SRX240 Services Gateway on page 69
.
AT&K0
.
AT&W
Copyright © 2013, Juniper Networks, Inc.