Table of Contents
Advertisement
SYSTEM OVERVIEW
TIMERS
The G1000 timers available include:
• Stopwatch-like generic timers (available from the PFD Timer/References Window and on the MFD AUX -
Utility Page)
• Total-time-in-flight timer (MFD AUX - Utility Page)
• Time since departure (MFD AUX - Utility Page)
The generic timer can be set to count up or down from a specified time (HH:MM:SS). When the countdown
on the timer reaches zero the digits begin to count up from zero. If the timer is reset before reaching zero
on a countdown, the digits are reset to the initial value. If the timer is counting up when reset, the digits are
zeroed.
Setting the generic timer (PFD):
1) Press the TMR/REF Softkey.
2) Turn the large FMS Knob to select the timer field (hh/mm/ss).
3) Use the FMS Knob to enter the desired time and press the ENT Key.
4) With the UP/DN field highlighted, turn the small FMS Knob to select the timer counting direction.
5) Press the ENT Key.
6) With 'START?' highlighted, press the ENT Key to start the timer. The field changes to 'STOP?'.
7) To stop the timer, press the ENT Key with 'STOP?' highlighted. The field changes to 'RESET?'.
8) To reset the timer, press the ENT Key with 'RESET?' highlighted. The field changes back to 'START?' and the
digits are reset.
9) To remove the window, press the CLR Key or the TMR/REF Softkey.
38
PFD
Figure 1-34 Generic Timer (Timer/References Window)
Garmin G1000 Pilot's Guide for the Diamond DA40/40F
190-00592-06 Rev. A
Advertisement
Table of Contents
