Flight Timers - Garmin GTN 725 Pilot's Manual

15.2
Foreword
The Flight Timers function provides count up/down timers, plus automatic
Getting
Started recording of departure time, and total trip time. Departure and total trip time
recording can be configured to run either any time unit power is on, or only
Audio &
Xpdr Ctrl
when your ground speed exceeds the in-air threshold set by the installer (for
example, 30 knots). A flexible Generic Timer is available for general timing
Com/Nav
needs.
FPL
NOTE: When a count up timer is used, the preset value has no function.
Direct-To
Proc
Start/Stop Generic Timer
Charts
Selected
Counter
Wpt Info
Direction
Select Preset
Map
Time
Reset Timer
Traffic
Select
Terrain
Criteria For
Timer Start
Weather
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
15-10
Index

Flight Timers

1. While viewing the Utilities page, touch the Flight Timers
key.
Figure 15-11 Utility Flight Timers Page
2. If the Generic Timer Direction counter is set to "Up," the Reset
Timer key will be shown and when touched will return the
timer to 00:00:00. If the Direction counter is set to "Down,"
the Preset Timer key will be shown and the key will return the
timer to the Preset time value.
3. Touch each key as desired to set up timer operation.
Garmin GTN 725/750 Pilot's Guide
Reset or Preset Timer
Elapsed
Time
Departure Time
(Local Time)
Set Departure Time
To Current Local
Time Of Timer Start
190-01007-03 Rev. D