Garmin Diamond DA40 Pilot's Manual page 36

OFF
SYSTEM OVERVIEW
• XPDR Displays transponder mode selection softkeys:
STBY Selects standby mode (Transponder does not reply to any interrogations)
ON Selects Mode A (Transponder replies to interrogations)
ALT Selects Mode C – altitude reporting mode (Transponder replies to identification and altitude
GND Manually selects Ground Mode (Transponder does not allow Mode A and Mode C
VFR Automatically enters the VFR code (1200 in U.S.A. only)
CODE Displays transponder code selection softkeys 0-7
Use numbers to enter code
0 — 7
BKSP Removes numbers entered, one at a time
• IDENT Activates the Special Position Identification (SPI) pulse for 18 seconds, identifying the
• TMR/REF Displays/removes Timer/References Window
• NRST Displays/removes Nearest Airports Window
• ALERTS Displays/removes Alerts Window
0
24
DCLTR TRAFFIC TOPO
DCLTR-1 TRFC-1
DCLTR-2 TRFC-2
DCLTR-3
PFD
interrogations)
(optional)
DFLTS WIND DME BRG1
replies, but does permit acquisition squitter and replies to discretely addressed Mode S
interrogations)
OPTN1 OPTN2 OPTN3
transponder return on the ATC screen
STBY ON ALT
1 2 3 4
Figure 1-19 XPDR Softkeys
Garmin G1000 Pilot's Guide for the Diamond DA40/40F
(optional)
(optional) (optional)
STRMSCP
TERRAIN NEXRAD XM LTNG
Press the OFF or BACK Softkey
to return to the top-level softkeys.
HSI FMT BRG2 ALT UNIT
Press the BRG1/BRG2 Press the STD BARO or BACK
softkeys to display/remove Softkey to return to the top-level
the Bearing Information softkeys.
windows and cycle through
bearing sources:
- NAV1/NAV2
- GPS
- ADF
OFF
360 HSI ARC HSI
METERS IN HPA
XPDR
VFR CODE IDENT
GND
Press the BACK Softkey to
return to the top-level softkeys.
5 6 7 IDENT
Press the IDENT or BACK
Softkey to return to the top-
level softkeys.
BACK ALERTS
STD BARO BACK ALERTS
BACK ALERTS
BACK ALERTS
BACK ALERTS
BACK ALERTS
BKSP BACK ALERTS
190-00592-06 Rev. A