Table of Contents
Advertisement
GIA 63W (CONT.)
Message Advisory
COM1 RMT XFR – COM1 remote
transfer key is stuck.
COM2 RMT XFR – COM2 remote
transfer key is stuck.
LOI – GPS integrity lost. Crosscheck
with other NAVS.
GPS NAV LOST – Loss of GPS
navigation. Insufficient satellites.
GPS NAV LOST – Loss of GPS
navigation. Position error.
GPS NAV LOST – Loss of GPS
navigation. GPS fail.
ABORT APR – Loss of GPS navigation.
Abort approach.
APR DWNGRADE – Approach
downgraded.
TRUE APR – True north approach.
Change HDG reference to TRUE.
GPS1 SERVICE – GPS1 needs service.
Return unit for repair.
GPS2 SERVICE – GPS2 needs service.
Return unit for repair.
NAV1 SERVICE – NAV1 needs service.
Return unit for repair.
NAV2 SERVICE – NAV2 needs service.
Return unit for repair.
NAV1 RMT XFR – NAV1 remote
transfer key is stuck.
NAV2 RMT XFR – NAV2 remote
transfer key is stuck.
G/S1 FAIL – G/S1 is inoperative.
G/S2 FAIL – G/S2 is inoperative.
G/S1 SERVICE – G/S1 needs service.
Return unit for repair.
G/S2 SERVICE – G/S2 needs service.
Return unit for repair.
190-00592-06 Rev. A
Comments
The COM1 and/or COM2 transfer switch is stuck in the enabled (or "pressed")
position. Press the transfer switch again to cycle its operation. If the problem
persists, the G1000 system should be serviced.
GPS integrity is insufficient for the current phase of flight.
Loss of GPS navigation due to insufficient satellites.
Loss of GPS navigation due to position error.
Loss of GPS navigation due to GPS failure.
Abort approach due to loss of GPS navigation.
Use LNAV minima when approach is downgraded.
Displayed after passing the first waypoint of a true north approach when the nav
angle is set to 'MAGNETIC'.
A failure has been detected in the GPS1 and/or GPS2 receiver. The receiver may still
be available. The G1000 system should be serviced.
A failure has been detected in the NAV1 and/or NAV2 receiver. The receiver may still
be available. The G1000 system should be serviced.
The remote NAV1 and/or NAV2 transfer switch is stuck in the enabled (or "pressed")
state. Press the transfer switch again to cycle its operation. If the problem persists,
the G1000 system should be serviced.
A failure has been detected in glideslope receiver 1 and/or receiver 2. The G1000
system should be serviced.
A failure has been detected in glideslope receiver 1 and/or receiver 2. The receiver
may still be available. The G1000 system should be serviced when possible.
Garmin G1000 Pilot's Guide for the Diamond DA40/40F
APPENDIX A
491
Advertisement
Table of Contents
