Garmin Diamond DA40 Pilot's Manual page 406

Integrated flight deck for da40 diamond star
Hide thumbs Also See for Diamond DA40:
Table of Contents

Advertisement

AUTOMATIC FLIGHT CONTROL SYSTEM
Vertical Path Tracking descent to VNV Target Altitude:
1) Select VNV flight control:
a) Press the VNV Key to arm Vertical Path Tracking Mode. The white annunciation 'VPTH' appears.
b) Using the ALT Knob, set the Selected Altitude below the flight plan's VNV Target Altitude of 10,000 feet.
If the Selected Altitude is not at least 75 ft below the VNV Target Altitude, the flight director captures the
Selected Altitude rather than the VNV Target Altitude once Vertical Path Tracking Mode becomes active (ALTS is
armed rather than ALTV).
c) If Vertical Path Tracking Mode is armed more than 5 minutes prior to descent path capture, acknowledgment is
required for the flight director to transition from Altitude Hold to Vertical Path Tracking Mode. To proceed with
descent path capture if the white 'VPTH' annunciation begins flashing, do one of the following
Press the VNV Key
If the descent is not confirmed by the time of interception, Vertical Path Tracking Mode remains armed and the
descent is not captured.
2) When the top of descent (TOD) is reached, the flight director transitions to Vertical Path Tracking Mode and
begins the descent to the VNV Target Altitude. Intention to capture the VNV Target Altitude is indicated by the
white 'ALTV' annunciation.
3) As the aircraft nears the VNV Target Altitude, the flight director transitions to VNV Target Altitude Capture Mode,
indicated by the green 'ALTV' annunciation flashing for up to 10 seconds.
The green 'ALT' annunciation flashes for up to 10 seconds upon reaching 50 feet from the VNV Target Altitude;
the autopilot transitions to Altitude Hold Mode and levels the aircraft at the vertical waypoint.
1
ALT Mode
394
TOD
Cruise Altitude of 12,000 MSL
2
VNAV Target Altitude of 10,000 MSL
Figure 7-35 VPTH Descent
Garmin G1000 Pilot's Guide for Diamond DA40/40F
Turn the ALT Knob to adjust the Selected Altitude
3
BOD
Selected Altitude (set below VNAV Target Altitude)
3 nm
ALT Mode
OPSHN
190-00592-06 Rev. A

Advertisement

Table of Contents
loading

This manual is also suitable for:

Diamond da40fG1000

Table of Contents