Table of Contents
Advertisement
FLIGHT MANAGEMENT
h) Press the ENT Key twice to activate the direct-to. Note, in Figure 5-121, the magenta arrow indicating the direct-
to OPSHN after the offset waypoint for OPSHN. The preceding offset waypoint indicates the offset distance
and altitude that were previously entered. The remaining waypoints in the loaded arrival procedure have no
database specified altitudes, therefore, dashes are displayed. Keep the CDI centered and maintain a track along
the magenta line to OPSHN.
Note the Direct-to waypoint is within the loaded arrival procedure, therefore, phase of flight scaling for the CDI
changes to Terminal Mode and is annunciated by displaying 'TERM' on the HSI.
If the loaded arrival procedure has waypoints with altitude constraints retrieved from the database
NOTE:
to be used as is, the altitude must be manually accepted by placing the cursor over the desired altitude,
then pressing the ENT Key. The altitude is now displayed as light blue meaning it is used by the system to
determine vertical speed and deviation guidance.
12) The aircraft is proceeding to OPSHN. The expected approach is the RNAV LPV approach to runway 35R, so it is
selected.
a) Press the PROC Key to display the Procedures Window.
258
Figure 5-121 Direct-to Active
Garmin G1000 Pilot's Guide for the Diamond DA40/40F
190-00592-06 Rev. A
Advertisement
Table of Contents
