Table of Contents
Advertisement
APPENDIX b
3) Apply power to the G1000 System. View the MFD power-up splash screen. Check that the databases are
initialized and displayed on the splash screen. When updating the terrain and FliteCharts databases, an 'in
progress' message may be seen. If this message is present, wait for the system to finish loading before verifying
the correct databases are initialized, then proceed to step 3.
4) Acknowledge the Power-up Page agreement by pressing the ENT Key or the right most softkey.
5) Use the FMS Knob to select the AUX - System Setup Page.
6) Select the DBASE Softkey to place the cursor in the 'DATABASE' box.
7) Turn the FMS Knob to scroll through the list and check that all databases are current and there are no errors.
8) Power down the G1000.
502
Figure B-4 Database Information on the Splash Screen
Garmin G1000 Pilot's Guide for the Diamond DA40/40F
190-00592-06 Rev. A
Advertisement
Table of Contents
