Table of Contents
Advertisement
AUDIO PANEL AND CNS
SELECTING ADF RECEIVER MODE
The following modes can be selected: (In all modes NDB audio can be heard by selecting the ADF Key on
the Audio Panel.)
• ANT (Antenna) – The ADF bearing pointer parks on the HSI at 90 degrees. Best mode for listening to NDB
audio.
• ADF (Automatic Direction Finder) – The ADF pointer points to the relative bearing of the NDB station.
• ADF/BFO (ADF/Beat Frequency Oscillator) – The ADF pointer points to the relative bearing of the NDB
station and an audible tone confirms signal reception. This mode allows identification of the interrupted
carrier beacon stations used in various parts of the world.
• ANT/BFO (Antenna/Beat Frequency Oscillator) – The ADF bearing pointer parks on the HSI at 90 degrees
while an audible tone is provided when a signal is received. This mode also allows identification of the
interrupted carrier beacon stations and confirms signal reception.
Selecting an ADF receiver mode:
1) Turn the large FMS Knob to place the selection cursor over the ADF mode field.
2) Turn the small FMS Knob to select the desired ADF receiver mode.
ADF receiver volume level can be adjusted in the tuning window from 0 to 100%. The default volume level
is set to 50%. The ADF volume level is the same for both Audio Panels.
Adjusting ADF receiver volume:
1) Turn the large FMS Knob to place the selection cursor over the ADF volume field.
2) Turn the small FMS Knob to adjust volume as desired.
116
Figure 4-32 Selecting ADF Receiver Mode
Figure 4-33 Adjusting ADF Receiver Volume
Garmin G1000 Pilot's Guide for the Diamond DA40/40F
Turn the Small
FMS Knob
to Select the
Mode
Turn the Small
FMS Knob
to Select the
Volume
190-00592-06 Rev. A
Advertisement
Table of Contents
