Fujitsu SPARC ENTERPRISE M9000 Service Manual page 451

g. Mount the dual power feed unit (with four screws) on the two poles at the
Note – When securing the rack-mountable dual power feed unit on the equipment
rack, keep it positioned close to the PSUs of the M8000.
Mounting the Screws of Rack-mountable Dual Power Feed (Rear of M8000)
FIGURE 24-3
h. Remove the right screw securing the connector unit at the rear of the dual
i. Mount the two brackets (mound shaped) on the two poles (with two screws
j. Secure the rear of the dual power feed unit on the two brackets (with three
k. Connect the bus bars that were mounted in
l. Connect the connectors of the four cables protruding from the rear of the
Chapter 24
front of the equipment rack of the M8000.
power feed unit, loosen the left screw, slide the connector unit to the right,
and remove it.
for each pole) at the rear of the equipment rack of the SPARC Enterprise
M8000 server.
screws each).
of the dual power feed unit by using the two bus bars (Z shape) from the
installation kit. Secure them with bolts. (Torque: 8.24 N*m (84 kgf*cm))
dual power feed unit to the DC1 connector panel.
Addition and Deletion of a RDPF Option, Power Cabinet, and M9000 Expansion Cabinet
screws (three on both sides)
Step b to the bus bar at the rear
24-7