Fujitsu SPARC ENTERPRISE M9000 Service Manual page 314

7. Ensure that the metallic underside of the wrist strap is in direct contact with
your skin. The wrist strap should be snug around the wrist so that it does not
rotate. See
Caution – Before handling FRUs, be sure to connect the clip of the antistatic wrist
strap and of the antistatic mat to the server grounding port, and attach the band of
the wrist strap to one of your wrists. Place the FRUs on the grounded antistatic mat.
Failure to take these antistatic measures might result in serious damage.
8. Remove the PCI cassette of the PCI card to be replaced.
Caution – To disconnect the link cable, which is a cable connected between the link
card mounted on the server and external I/O expansion unit, pull the latch lock of
the connector. If you forcibly pull the connector or the cable, the cable may be
damaged.
Caution – When removing cables such as LAN cable, if your finger can't reach the
latch lock of the connector, press the latch with a flathead screwdriver to remove the
cable. Forcing your finger into the clearance can cause damage to the PCI card.
a. Using a Phillips screwdriver, loosen the green screw securing the lever.
b. While grasping the upper part of the PCI cassette, pull the lever until it is
c. Place the removed PCI cassette on an antistatic mat.
9. Remove the PCI card from the PCI cassette. (Perform the work on the
conductive mat.)
a. While grasping the lock bracket, turn it in the direction of the arrow and
b. Loosen the two screws at the rear of the PCI cassette, slide out the latch, and
Note – Do not loosen the screws at the bottom because they are used as a reference
position.
c. Slide the PCI card in the direction of the arrow to remove it. (See
13-22 SPARC Enterprise M8000/M9000 Servers Service Manual • June 2010
Section 1.4, "Antistatic Precautions" on page
stopped, and continue pulling it to pull out the PCI cassette.
push the lever a little. Then, push in the lever completely. (See
Once you start moving the lever, the lock bracket need not be held.
secure it with screws. (See )
FIGURE 13-4
1-6.
FIGURE 13-3
FIGURE 13-5
)
)