Fujitsu SPARC ENTERPRISE M9000 Service Manual page 358

FIGURE 17-3
1
9. Place the removed crossbar unit on an antistatic mat, and then install the
replacement crossbar unit.
10. While grasping the eject/lock levers, properly align the crossbar unit with the
slot guide, and then gently insert it.
Caution – If you are unable to obtain a torque screwdriver, finger tighten the clock
cable connectors. Do not secure them with a regular screwdriver.
Caution – Do not forcibly push the crossbar unit in when inserting it. If the crossbar
unit is forcibly inserted despite the presence of any obstruction in a slot or any
problems with the connector pin, serious damage may result.
11. Lock the eject/lock levers to affix the crossbar unit to the back plane.
17-6 SPARC Enterprise M8000/M9000 Servers Service Manual • June 2010
Removing the XBU (Front of the M9000 Base Cabinet)
2
1