Setting The Rs-232C Communication Conditions - Omron NT-series Operation Manual

4-6-4

Setting the RS-232C Communication Conditions

When connecting the NT600S to the host by the RS-232C method, set the follow-
ing communication conditions.
Item
2400/4800/9600/19200bps
RS-232C Speed
(to be set to the same value as set for the Host)
Data bit length 7 bits/8 bits
Stop bit length 1 bit/2 bits
Parity bit Even/odd/none
RS/CS control
Flow control
XON/XOFF control
None
Select the required menu option from the System Menu by following the procedure
given below.
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ MAINTENANCE MENU ]
Quit
PT Setting Status
I/O Check
Memory Init.
Memory Switches
[ MEMORY SWITCH MENU (1/2) ]
Comm. Method
Key Press Sound
Buzzer Sound
Putting-Out Time
Resume Function
Support T ool Mode
Setting
Select "Maintenance Mode".
Select "Memory Switches".
Display History
Press "NEXT PAGE".
If the RS-232C has been se-
EXIT
lected, the host link speed set-
RS-232C
ting does not make any effect.
OFF
NEXT
OFF
PAGE
None
SAVE
ON
EXIT
NT600S
Section 3-6
Factory-Setting
2400bps
8 bits
1 bit
None
None